Job Title: RF Design Engineer

<p style="margin: 0px; font-family: Times New Roman;">Applicant will be responsible for design, analysis and implementation of active and passive RF circuits up to 6 GHz for low-noise, high-dynamic range receiver circuits. Application of solid RF layout, isolation and shielding techniques.</p><p style="margin: 0px; font-family: Times New Roman;">&nbsp;</p><p style="margin: 0px; font-family: Times New Roman;">Applicant will be responsible for documentation releases including parts lists, assembly drawings, test requirements and procedures. Applicant will work on the bench and provide guidance to technicians.</p><p style="margin: 0px; font-family: Times New Roman;"></p><p style="margin: 0px; font-family: Times New Roman;"></p><table style="font-family: Times New Roman;" width="100%" border="0" cellpadding="0" cellspacing="2"><tbody><tr><td class="iCIMS_InfoField iCIMS_InfoField_Job"><strong><br><br>Basic Qualifications</strong>:</td> </tr> <tr> <td class="iCIMS_InfoMsg iCIMS_InfoMsg_Job"><ul><li>BSEE or equivalent.&nbsp; </li><li>MSEE desired.</li><li>7 years minimum related experience.</li><li>US Citizenship is required for purposes of obtaining a US government security clearance.&nbsp; A Secret clearance is required for this position.</li></ul><br></td> </tr> <tr> <td class="iCIMS_InfoField iCIMS_InfoField_Job"><strong>Other Requirements</strong>:</td> </tr> <tr> <td class="iCIMS_InfoMsg iCIMS_InfoMsg_Job"><ul><li>Experience designing and analyzing new Receiver (Broadband, multi-channel, high-dynamic range) and Synthesizer architectures (PLLs, Multi-loop, Direct-Synthesis, DDFS). </li><li>Cognizance of Spurious, Phase Noise, Dynamic Range, BIT, Size, Weight, Power, Design for Manufacturing and Test tradeoffs is necessary. </li><li>Experience with Receiver circuits and analysis from HF to microwave (Antennas, Filters, LNAs, Mixers, Oscillators, Detectors, ADCs, Power Supplies) using linear and non-linear tools (SPICE, Eagleware, Matlab) is required (EM-simulation capability is desired). </li><li>Circuit board design familiarity using ORCAD and PADS and disciplined documentation practices are required. </li><li>Board, module, and system test experience (including solid trouble-shooting and rework skills) are needed. </li><li>Familiarity with RF test equipment and measurements: Spectrum Analyzers, Network Analyzers, Signal Generators, Oscilloscopes, Power Meters for (Phase Noise, IP3, Swept Gain, Spurs, Noise Figure, etc).</li></ul></td></tr></tbody></table>